Tyre care

Tyre tread and pressure: a practical checking guide

A quick look at the tyres is useful, but it does not replace checking their pressure and tread. Use these three checks together, especially before a longer journey or when a warning light appears.

By WeWantTyresPublished 3 min read
Illustration of a tyre with a pressure gauge and tread depth gauge.
Illustration

The key point

For cars, the legal tread minimum is 1.6mm across the central three-quarters and around the whole tyre. Check pressure against the vehicle manufacturer's settings and inspect for damage too.

Check tread in more than one place

GOV.UK states that cars, light vans and light trailers need at least 1.6mm of tread across the middle three-quarters and around the tyre's entire circumference. A current MOT does not remove your responsibility to keep the vehicle roadworthy.

Use a tread-depth gauge in the main grooves at several positions across and around each tyre. A single reading from an easy-to-reach part can miss uneven wear. If a result is close to the limit or you cannot inspect the tyre properly, have it assessed before relying on it for a journey.

Use the 20p test as a guide

TyreSafe describes inserting a 20p coin into the main tread grooves and checking whether the outer band remains visible. If it does, the tyre may have insufficient tread and needs prompt professional checking. Repeat at several points rather than checking just once.

A coin gives an indication; it is not a precise measurement or a check of the tyre's internal condition. Do not use one good-looking patch of tread as a reason to ignore wear elsewhere.

Use the pressure specified for your vehicle and load

Find the recommended settings in the vehicle handbook or pressure placard. Front and rear values can differ, and the correct setting may change with passengers or luggage. Check with an accurate gauge when the tyres are cold and include the spare if your vehicle has one.

Use the vehicle's recommended pressure, not the maximum pressure moulded onto a tyre sidewall. Keep the units consistent: a figure in bar is not the same number in psi. Follow the handbook for any pressure-monitoring reset after a check or tyre change, and do not ignore an alert that returns.

Look for damage as well as wear

Check visible tyre surfaces for cuts, cracks, bulges and unusual wear. Tyres must be free from defects as well as having sufficient tread. If you find damage or the tyre repeatedly loses pressure, arrange an assessment rather than assuming topping it up has resolved the cause.

Carry out checks where the vehicle is safely parked, away from moving traffic. Do not put yourself underneath an unsupported car to inspect a hidden surface. Tell a professional when you cannot see enough to judge the condition.

Turn your checks into a useful enquiry

Keep a note of which wheel has the problem. If you have measured tread, record the readings and where they were taken. For pressure loss, note when the warning appeared and whether it has happened before. These observations help explain the issue without guessing the cause.

If replacement is needed, send the tyre size, sidewall markings, number of tyres and your location to WeWantTyres. We can discuss suitable options and fitting at home, work or another safe, accessible location. Confirm the work, total price and appointment through WhatsApp before treating it as booked.

Sources and further reading

Sources checked on 17 October 2026. Follow the vehicle manufacturer's instructions and have a tyre professional assess damage or uncertain readings.

A quote before you book

Time to arrange replacement tyres?

Send your tyre size, location and the number of tyres you need. We will confirm options, price and fitting availability.

Start my quote
All tyre advice